[Dxbase] Help with Vista Problems.. on New Dell

[Emil Tillona]

Problem #1

 

I finally got around to installing DXbase 2007 on my new Dell with Vista
Ultimate.  I was not able to run the Help files.  I found a fix on the
Microsoft site and uploaded a small program from them.  

 

Now I can get the help menus, put after I enter a topic I get that help
screen and a message the says "Problems with Macro (1037)"  I can view that
screen but can't go back to main menu again.  I have to exit and then start
the procedure again if I need more info.

 

Has anyone experienced this, if so, did you find a fix.

 

Next Problem #2.  

 

I have installed DX Atlas ver 2.25.  When I connect, DXBase 2007 locks up
completely.  I have the appropriated box Checked as greater than 2.1.. any
suggestions.  I have to use task manger to kill the program. 

 

 

Emil Tillona

etillona at sbcglobal.net

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mailman.qth.net/pipermail/dxbase/attachments/20081214/5ff4bacd/attachment.htm