[Dxbase] MMD/DX Base interface notes

[FireBrick]

My rig is a ft1000mp.
I operate rtty in fsk mode using the RTY button.
I operate psk via the PKT button which is really sending out a audio signal in LSB.

I can now use the new add in mdd.exe and mmtty.exe and as I have the frequency turned off 
in mdd.exe, it logs mmtty station as rtty in DXBAse
If I switch to Joe's new DXBPSK, my rig is now in PKT/LSB mode and qso's automatically are 
logged as DIGITAL/PSK31.


----- Original Message ----- 
From: "Peter Dougherty" <w2irt at comcast.net>
To: "DXBase List" <dxbase at mailman.qth.net>
Sent: Thursday, November 09, 2006 16:16
Subject: [Dxbase] MMD/DX Base interface notes


> Hi all,
>
> After trying MMD with MMTTY and DX Base, here are a couple of suggestions. IF you have 
> frequency control interfaced to DX Base already, you must go into MMD, Options, DX Base 
> and turn off sending frequency information to DX Base (i.e. check the do-not-send 
> option). Otherwise it will send 14000.0 to DX Base (or whatever the default band is in 
> MMTTY's setup) instead of the actual operating frequency.
>
> In DX Base, if you don't use anything OTHER than RTTY as a digital mode (no PSK or 
> anything else), make your default PSK mode RTTY. This will populate the MODE column with 
> RTTY when you use MMTTY. Otherwise, so far, I've found no other combination of settings 
> that will allow an MMTTY QSO to show up as RTTY and a PSK-31 QSO to show up as DIGITAL 
> in the MODE column.
>
> Since I don't operate any PSK or Olivia, etc, that's fine for me, but if anybody has a 
> way to log PSK/etc as DIGITAL and MMTTY RTTY contacts as RTTY, I'd love to know.
>
>
>
> Cheers,
>
> Peter,
> W2IRT
>
> ______________________________________________________________
> Dxbase mailing list
> Home: http://mailman.qth.net/mailman/listinfo/dxbase
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Dxbase at mailman.qth.net