[Dxbase] Wrong zone

[Bob]

Greetings, I am looking for some advice on entering qso's into the log.

I was working a pileup last night and entering the calls into my log. 
Typically, I would enter the call, tab over to the name and notes to 
record the other info. A few times I would only have a partial call or I 
might have gotten the prefix wrong. When this happened, DXbase would 
load the mistyped country, zone info and call prefix into the fields and 
not update when I correct the callsign.

Is there a way to reset those fields while entering the call and/or 
after the qso is logged?

What I had to do was either clear out all the info and start over or log 
it and afterwards start to enter a new QSO and copy those 4 fields to 
the original QSO.

Bob - N6RI