[Dxbase] IC706MKIIG

[JV]

Hi Larry 
    Computer control is on Com-1, CW is on LPT-1 and RigBlaster is on Com-7
(two serial port card from Byterunner). All other settings are as you
mention. I may try putting the computer control on Com-6 (the other serial
port via Byterunner) but I don't think it will make any difference. Don't
have any thing to loose, hi hi. 
    The main computer is linked to an IC-756pro and all programs work OK on
it. 
    Both computers are the same, Dell 2.4 XP. 
    If all options fail, I am going to delete DXBase2005 and do a new
install. Just don't understand why N1MM and DXLab programs work and DXBase
doesn't. 
    Going to take a ride up into the mountains and clear my head. Tks for
the information.
JV 
 
-------Original Message------- 
 
From: Larry Strasser 
Date: 03/14/06 09:51:34 
To: Dxbase at mailman.qth.net 
Subject: [Dxbase] IC706MKIIG 
 
JV, 
 
I am using DXBASE "2006" with my 706mkIIG.( The setings should be the 
Same in DXBase 2005) 
 
Does your computer have a "legacy" serial port or are you using a 
USB/SERIAL adaptor? 
 
Make sure you have the folowing checked or selected: 
 
"Manufacturer" = ICOM. 
"MODEL" = IC-706MKIIG. 
"CTS" checked and "Connect HF Radio 1 Serial Interface" checked. 
 
Make sure you have the correct "Comport" selected. 
 
 
I am using the following parameters: 
BAUDRATE = 1200 
PARITY = NONE 
WORD LENGHT =8 
STOP BITS = 1 
 
I have the IC-706MKIIG internal parameters selected for 1200 baud. 
 
I am using 2 USB/SERIAL adaptors on my Dell laptop along with WINKEY. 
 
I hope this helps. 
 
73, Larry 
 
DXCLUSTER DXC.K2LS.COM 
Spots from NA zones 1-8 only. 
 
 
 
______________________________________________________________ 
Dxbase mailing list 
Home: http://mailman.qth.net/mailman/listinfo/dxbase 
Help: http://mailman.qth.net/mmfaq.htm 
Post: mailto:Dxbase at mailman.qth.net 
 
 
-- 
No virus found in this incoming message. 
Checked by AVG Free Edition. 
Version: 7.1.375 / Virus Database: 268.2.2/280 - Release Date: 3/13/2006