[Dxbase] frequency readout

[Art Holmes]

Hello dxbasers, I have a cockpit problem! I am unable to get the correct
frequency readout from the rig. It always comes up frequency 365416.5 and
band 75gh. It has worked in the past. I have n1mm logger for contesting and
it works fine.

The setup:

Rig icom 756pro2  the rig is selected with addr of 64h

Interface  via ct17   1200 n 81 dtr cts  on com 3    same with n1nn

Load band/mode from transceiver is set

The mode readout is correct just frequency wrong

The rig will set the xcvr freq via spot correctly

Under radio 1  connect hf radio serial is set

The default band is set at 2

 When the 756pro2 is powered off the 2 m default is set correctly

There is a 2nd rig an ft736r but it is not connected via rs232

In the log page you can suspend the radio use, that is not set

Any ideas.? Thanks art w1rzf