[Dxbase] Incorrect Frequency Entry

[JV]

    I should have mention that the operating frequency was 6 meters and 
I had QSOs at different intervals, ie, 50.130, 50.150, 50.175 etc.
    Last night I open the DX Lab programs which is used with two monitors. 
I then open DX Atlas in monitor two. Entered a few contacts, 6M, using 
WinWarbler which is on monitor one. All QSOs were put into DXKeeper, 
which is on monitor two, with the correct frequency.
=================================


     Ran into a strange problem last night (last Thursday now). I had
monitor 
1 set to DXBase 2005 and Monitor 2 to DX Atlas 2.25. After I had logged 
serval QSOs, I happen to look at the frequency that was logged. All QSOs 
were 363416.56 and the band was 75. I closed DX Atlas and the frequencies 
would be logged OK. Open DX Atlas back up and got the same problem. 
Anyone have this happen to them and if so, what's the cure. Using 2.4 MHz 
and XP pro. Rig is an IC-756 pro.
 JV