[Dxbase] Rotor Interface

[Al Bailey]

Oooops I meant with Ham V you get DCU-1 ... SRI



At 01:26 PM 4/14/2005, Al Bailey wrote:
>Ham IV and Ham V are exact same rotor BUT with Ham IV you get the DCU-1 
>controller...
>
>
>
>
>
>At 01:20 PM 4/14/2005, Jack wrote:
>>I am unfamiliar with there being a Hygain HAM V.  I know that there was a 
>>Ham IV and also a Tx2.  In any case, the answer of whether a rotor would 
>>work with software control from DXbase would depend upon the rotor 
>>control box's ability to support RS232 interface, and whether the 
>>commands required could be set up in DXbase user options.  Or possibly 
>>the rotor emulates the commands of some other existing rotor and could 
>>therefore use that.
>>
>>Regards,
>>Jack
>>
>>----- Original Message ----- From: "JNMazzoni" <JNmazzoni at comcast.net>
>>To: <dxbase at mailman.qth.net>
>>Sent: Thursday, April 14, 2005 11:28 AM
>>Subject: [Dxbase] Rotor Interface
>>
>>
>>Is dxbase 2005 compatable with hy-gain's HAM-V rotator?
>>______________________________________________________________
>>Dxbase mailing list
>>Home: http://mailman.qth.net/mailman/listinfo/dxbase
>>Help: http://mailman.qth.net/mmfaq.htm
>>Post: mailto:Dxbase at mailman.qth.net
>>
>>______________________________________________________________
>>Dxbase mailing list
>>Home: http://mailman.qth.net/mailman/listinfo/dxbase
>>Help: http://mailman.qth.net/mmfaq.htm
>>Post: mailto:Dxbase at mailman.qth.net
>
>
>
>______________________________________________________________
>Dxbase mailing list
>Home: http://mailman.qth.net/mailman/listinfo/dxbase
>Help: http://mailman.qth.net/mmfaq.htm
>Post: mailto:Dxbase at mailman.qth.net