[DXBase] Radios.ini/filter select?

[Alf Jacob Munthe]

----- Original Message ----- 
From: "Stephen M. Murphy" <murphys@comcast.net>
To: <dxbase@mailman.qth.net>
Sent: Saturday, March 13, 2004 5:27 PM
Subject: [DXBase] Radios.ini/filter select?


Hi,

When I "grab" a CW cluster spot with DXBase, it will change my CW mode to
"Wide" by default (Rig is IC-765) when performing the QSY.  Is there a way
to have it use CW/N instead, perhaps by modifying the radios.ini file?

Thanks and 73,

Steve N8NM

Steve!
If you check the rigs serial protocol. you might find the code for CW-N. In
the radios.ini, the CW and P-CW is sat up with 3 for this radio. Maybe you
can substitute with the CW-N number if it exsists? I don't have the protocol
for this rig.

Alf