[Dxbase] KPC3 WITH Dxbase 2005

[Kamar]

Raymond,

I run a KPC3 with Dxbase 2005 without any problems.  

To get out of the TNC's command mode and back into its conversation mode
click the Dxbase 'VHF Packet tab; your cursor should be blinking in the
entry line.  Next, type in the command: conv and then press your Enter or
Return key.

This should have put you back into the conversation mode, which will allow
you to use the TNC.



Ron
NU1U

PS  Ctrl-C will put you back into the 'command' mode.

 

-----Original Message-----
From: dxbase-bounces at mailman.qth.net [mailto:dxbase-bounces at mailman.qth.net]
On Behalf Of Raymond Phillips
Sent: Tuesday, June 08, 2004 04:25
To: Dxbase
Subject: [Dxbase] KPC3 WITH Dxbase 2005

Hi All
       Have been trying to get a KPC3 working with
dxbase2005 I can do a connect to a dxcluster and get connected but for some
reason I cannot get out of cmd mode all commands go to tnc e.g sh/u or sh/dx
which the tnc does not understand anybody no any settings I need to check
any help appreciated

Rgds Raymond GM0VRP


	
	
		
____________________________________________________________
Yahoo! Messenger - Communicate instantly..."Ping" 
your friends today! Download Messenger Now
http://uk.messenger.yahoo.com/download/index.html
_______________________________________________
Dxbase mailing list
Dxbase at mailman.qth.net
http://mailman.qth.net/mailman/listinfo/dxbase