[DXBase] Baud rate on my 756Pro w/DXB2004

[FireBrick]

----- Original Message ----- 
From: <SamuelR717@aol.com>
To: <dxbase@mailman.qth.net>
Sent: Saturday, January 17, 2004 2:32 PM
Subject: [DXBase] Baud rate on my 756Pro w/DXB2004


> After my sucess in getting DXB2004 working with the 756Pro, I went back and
> set the transcvr baud rate to "Auto" and experimented with changing the data
> rate in the program.  With the "Pace" set at 10 in DXB, all speeds up
> to/including 9600 worked perfectly; higher speeds failed.  I assume that changing the
> pace back to 5 would support higher speeds, but the 9600 is more than adequate
> for my use.
>
> I'm declaring a victory and getting out!
>
> Again, thanks to all who helped.

Carefull, Dewey did that to Truman.

I never declare computer victories, I proclaim a 'cessation of hostilities'! LOL



-----------------------------------------------------
New York State Motto: You Have The Right To Remain Silent, You Have The Right To An
Attorney
-----------------------------------------------------

Bill H. in Chicagoland