[Dxbase] 756 Pro II and PW-1

[Karl Geng, N1DL]

Greg,

I had the same problem with the IC7800 the PW1 and DXbase.
The solution was to change some parameters in DXbase.
I will look in my email history file and send you the
specifics.
Karl N1DL

-----Original Message-----
From: dxbase-bounces at mailman.qth.net
[mailto:dxbase-bounces at mailman.qth.net]On Behalf Of Greg - N4CC
Sent: Tuesday, December 21, 2004 11:09 AM
To: dxbase at mailman.qth.net
Subject: [Dxbase] 756 Pro II and PW-1


Merry Christmas, everyone...

I have an issue that I would love to have some help with if anyone knows
any tricks...  I have an Icom 756 Pro II and a K1NU interface...it works
fine with DXBase... I bought a PW-1 and connected it as the diagram shows
so that the amp and the radio and the computer interface all come together
in a Y connector at the back of the radio.  The amp syncs with the radio
and bandswitches successfully with the radio.  DXBase imports "garbage" for
the frequency (and hence the band as well) and sometimes it gets the mode
right ... sometimes not.

A little aside -- sometimes if I log something after changing bands, DXBase
does get some of the correct info -- but only the first time I try to log
something.

Settings have remained the same -- using 5Ch so I can use it with Writelog
as well.  Using 4800 baud and yes "transceive" is on in the radio.  Radio
works fine with the software...only when I add the PW-1 to the mix does the
radio info get garbled.

Anyone have any suggestions to try?  Thanks.  73 de Greg-N4CC

______________________________________________________________
Dxbase mailing list
Home: http://mailman.qth.net/mailman/listinfo/dxbase
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Dxbase at mailman.qth.net