[DXBase] Reseting the Freq.

[Chris Poulson]

At 23:11 14/04/2004, Bob Main wrote:
>I have a Yaesu Mark V and noticed that when I press Alt-R or select "Reset 
>HF Frequency" that the main receiver (VFO-A) goes back to where I expect 
>it to.  The problem is that the Sub Receiver (VFO-B) also resets, but to 
>some off the wall freq.  For example T33C was on 28.495.00 last night and 
>today I clicked on a DX Spot that changed VFO-A to the frequency in the DX 
>spot.  I then pressed Alt-R VFO-A went back to 28.495.00, but VFO-B went 
>to 1.243.78.  Got any clue why it would do that?
>
>Thanks,
>Bob
>KB4CL
I get the same results with a 756 Pro II and Tentec Orion, I reported this 
a month or so ago but has not been acknowledged as a bug yet!.
At first I thought it was just down to the 756 Pro II so I just disabled 
the VFO B option, but when I recently tried a Tentec Orion and got the 
exact same results, I new then, there was a problem within DXBase rather 
than the Radios.ini file.
Perhaps now that this has been reported, it may be fixed in the next 
release of DXBase?.

Chris Poulson