[DXBase] CW w/DXBase 2003

[Joe - WL7M]

Anyone know how to register a driver without having to re-install the 
DXbase 2003 program??  Seems that DriverX didn't register when I installed 
the program.

73,
Joe
WL7M


>Ouch ouch ouch.....brain freeze!  Well, I'm learning about computers, 
>Bill!  Thanks!
>
>I checked the DriverX.sys and DriverX.vxd, and they are only in the 
>Scientific Solutions folder, not in the Drivers directory.  I will copy 
>them to that folder.
>
>The Device Manager Show Hidden Devices did NOT reflect DriverX.  Guess 
>that may be the issue.  Now all I need to know is how to "register" it.....
>
>Thanks for your help!
>
>Joe - the new guy
>WL7M
>
>At 12:53 PM 2/4/2003, you wrote:
>>Ok
>>Well I don't use the lpt port, I use com ports. So I hope the my ideas
>>apply.
>>If the I/O address of the lpt matches the range listed in the Registry than
>>we should look at two other issues.
>>1. Are the files DriverX.sys & DriverX.vxd which can be found in the DXBase
>>directory also in Windows/System32/Drivers directory.
>>They should have been placed there during the Installation. If not,
>>copy/paste them into there.
>>
>>2. In Device Manager, Click on View and select Show Hidden Devices.
>>Back in Device Manager, select Non-Plug and Play Drivers
>>If DriverX is not included that means that the driver was not 'Registered'.
>>Sometimes it appears but is 'grayed' out.
>>If 'grayed' out, a right click will 'Enable' it.
>>
>>Here's where I fall down. I can never remember the commands to "Register a
>>Driver"
>>It's done from the 'Run' command box.
>>Maybe one of our readers can refresh my old, feeble, Alzheimer's mind.
>>
>>Hope this helps