[DXBase] Label printing: specifying starting location on label sheet

[Richard Karlquist]

I would like to print labels on 5161 label
sheets, which have 20 labels per sheet.  If
I print less than 20 labels, then I have a
partial sheet left over.  If I want to use
up this sheet, I need to get the printer
to start at the first unused label.  Is there
a way to tell DXBase to do this?  The only
way I can figure out to do it would be to
create 20 versions of the label design, with
the starting position hardwired in.  Then
I would select the correct version for the
number of labels remaining on the sheet.

This seems like it would be a common problem,
but I see no mention of it.  Does everyone
just print in batches of 20?

Rick Karlquist    N6RK
richard@karlquist.com
www.n6rk.com
www.karlquist.com