[DXBase] Radio Control

[Terry@k8smc.com]

Just upgraded from DXB2003 to DXB2004 Everything seemed fine.  Got my 
TS-950SDX back today and tried to set up radio control.  Not using any 
Comports for anything else.  Went to Options and set Radio 1 for Kenwood 
TS-950 and checked to see if everything was set the same as in 
2003.  Checked Radio 2 set up and it is not checked in Connect to Radio, 
same with Rotor Controls.  As far as I can determine everything is shut off 
except for Radio-1 which is checked.

When I left click on QSY in DX Info Window it tells me HF Radio failed to 
respond, I click on No and it does the same thing three or four times.

The TS-950 just had the RS-232 port repaired so I was real worried it 
wasn't fixed.  I pulled up DXB2003 and everything works fine.

I switched to my TS-690S radio (IF-232C and same cables) still using 2003 
and it worked fine also.

I then called up 2004 again with the TS-690S and got the same response I 
got with the TS-950SDX except after the third No is selected the 690 
finally responds and works the same way every time I try to QSY.

What am I missing?  Looking at the Radio INI files for both 2003 and 2004 
they look very similar.  I tried replacing the 2004 with INI file from 2003 
and it still worked the same way.

If I can get some suggestions I'll report back with info.

Terry K8SMC

K8SMC Node Support Pages: http://www.k8smc.com
K8SMC Node Connection: telnet://k8smc.com or telnet://198.109.212.235