[DXBase] Problem with Lat, Long, Callsign in Summary

[Tom]

--- Jack <jack@dxbase.com> wrote:
> Tom,
> 
> The comments from Bill and Tony are both correct.  In the summary window, if
> you are entering a call with the category type of HF Country, then you are
> getting a heading computed to the center of the US.
TOM===>Ok, that's what I'm getting.  


If you want a beam
> heading to a specific State, then change the category to HF States and then
> enter the two letter abv for the State.
TOM===> That does NOT seem to work  


If you want a beam heading to a
> specific callsign, then enter it in the log, press tab.  If the lat/lon for
> that call are on the CD you are using DXbase will use it.  If not, then it
> will use a default to center of the country.  To cancel the entry you put in
> the log, press the ESC key.

Tom===> This works OK

But it doesn't work if I type the callsign in the callsign box in the Summary window. I would
think that doing this would give me the heading to that callsign


Tom, N0YD

__________________________________________________
Do You Yahoo!?
Send FREE video emails in Yahoo! Mail!
http://promo.yahoo.com/videomail/