[DXBase] PACKET INTERFACE WITH ICON IC-2100

[FireBrick]

Not sure what the question is?
To make the packet tnc work with your rig and DXB, you must have the tnc
connected to the computer via a com port and the rig connected to the tnc.
Been a while since I hooked up my tnc but I know you have to connect audio
in and audio out wires as well as a ptt.
I'm sure you can make some sort of adapter that plugs into the mike
connector.
Doesn't the Icom have a connector on the back that accepts a tnc connection?

----- Original Message -----
From: <Kd2qk@aol.com>
To: <DXBASE@MAILMAN.QTH.NET>
Sent: Saturday, April 13, 2002 9:13 AM
Subject: [DXBase] PACKET INTERFACE WITH ICON IC-2100


> Hello All:
>        I may have sent this call for help before.  However, in that I did
not
> received a single response, maybe it didn't go out.
>
>        I am new to the DXBASE software and learning every day.  I recently
> bought an ICOM IC-2100 two meter rig and would like to interface it with a
> Kantronics KPC3.  The radio has one of those new telephone type microphone
> connectors. . . . . so I was wondering if anyone out there had been in the
> environment and had the answer.  Marty.
>
>
> _______________________________________________
> DXBase Reflector - Please visit us on the web at www.dxbase.com
> - - - - - - - - - - - - - - - - - - - - - - -
> To UNSUBSCRIBE please visit:
> http://mailman.qth.net/mailman/listinfo/dxbase
>
>