[Dx4win] DX4win inerface with TS890S

[ON4AOI]

Andy,
I created this driver and it works 1000% correct.
Looks like you set something for the keyer.
Are you using the dx4win keyer or winkeyer ?
Or are you using the build in cw keyer in ts890s ?

Guy ON4AOI

-----Original Message-----
From: dx4win-bounces at mailman.qth.net <dx4win-bounces at mailman.qth.net> On
Behalf Of Andy Hewitt via DX4WIN
Sent: Tuesday, October 28, 2025 12:09 PM
To: dx4win at mailman.qth.net
Subject: [Dx4win] DX4win inerface with TS890S

Hi 

I have been having PC problems which have caused me pain and suffering! 

In particular with DX4Win.

 

I have gradually worked through them and am more or less there now. The PC
talks to the rig and vice versa, psk rotator is working, the linear is
working,  

But now I have a key down signal from DX4Win all the time, no matter what
mode I select. This is new as It was not there before I rebooted the PC
yesterday. 

 

It stops if I stop the radio CAT control from DX4Win. I can only assume that
before the reboot I changed something without intending to.

 

The cw paddle works fine without the CAT control, but not when I restart
RADIO.

Any ideas chaps?

 

73

Andy G3SVD

 

______________________________________________________________
DX4WIN mailing list
Home: http://mailman.qth.net/mailman/listinfo/dx4win
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:DX4WIN at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html