[Dx4win] Connecting K3 and KX3 to DX4WIN.

[Mike Cizek W0VTT]

Hello Jim,

Use the following settings for the K3:
Radio Type: Elecraft K3
Address: 00
Baud Rate: 38400
Do NOT check either DTR or RTS high

If you are using an older K3 with the 9 pin serial port interface and a USB
to serial adaptor, use an adaptor with the FTDI chipset.  These settings
have worked just fine here for the past 13 years with both the original K3
and a K3s on Win XP, Win7, Win10, and Win 11.

----
73,
Mike Cizek W0VTT

-----Original Message-----
From: dx4win-bounces at mailman.qth.net <dx4win-bounces at mailman.qth.net> On
Behalf Of Jim Pyle
Sent: Saturday, 22 October, 2022 16:34
To: dx4win at mailman.qth.net
Subject: [Dx4win] Connecting K3 and KX3 to DX4WIN.

I just received and installed DX4WIN on my Win 10 computer.  No matter what
combination of settings I tried, I couldn't get them talking.  The K3 data
was not received by DX4WIN including band, frequency, mode nor was the
packet cluster info.  A setup file does not exist for the KX3.  If anyone
out there has experience with these radios, I look forward to hearing from
you ______________________________________________________________
DX4WIN mailing list
Home: http://mailman.qth.net/mailman/listinfo/dx4win
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:DX4WIN at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html