[Dx4win] DX4WIN and WJST-X/FT8

[Artek Manuals]

I am trying to run wjst-x on my Kenwood TS990S and of course log my 
contacts in DX4WIN

The 990 uses a USB connection which is seen as a virtual comport (COM3). 
I run into conflicts when I try to run DX4WIN and WJST-X because I think 
they are sharing or not sharing as the case may be the same COM port

I want to work a FT8 contact and then log it in DX4WIN. To do this at 
the moment I make a QSO on WJST-X/FT8 , then close WJST-X and open 
DX4WIN  ( or let DX4WIN /Radio interface time out and then log the 
contact manually  A bit cumbersome in the digital age.
So what do you guys do?
1) Manually transfer the info to DX4WIN after the radio connection times 
out, have to remember to enter all the band data, etc

2) The 990 has in addition to the USB virtual COM connection, a real COM 
port I suspect but have not tried it that I could run both the USB/COM 
and the REAl/COM dedicate one port to DX4WIN and dedicate the other 
connection to WJST-X

3) WJST-X has a loging mode, so just log everything to WJST-X and then 
import that log into DX4WIN later ?

4) Or ???? Some possible permutation and combination I haven't 
considered yet



Dave
NR1DX
manuals at artekmanuals.com
nr1dx at arrl.net




---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus