[Dx4win] WAS Not Showing All States Worked

[Bud Governale, W3LL]

I noticed my 30M WAS count was low.
Reports>WAS>Summary. Band, Mode, Mixed, All modes, All Bands selected. 
Summary shows 1 Worked and 3 Confirmed on 30M.
Reports>WAS>Listing shows the same as the Summary.

So I worked many states on 30M over the past few days on FT8
using WSJT-X with JTAlert.

I take the JTAlert log.adi and run it thru ADIFLOOKUP.
This utility uses QRZ.COM to wash thru all the logged contacts thru QRZ.COM database, adding the missing info such as name, address, State, County, Country etc etc.
I then take the ADI output from ADIFLOOKUP and import it into DX4WIN.
Been doing this for at least the past 10 years. The utility is worth its weight in gold, especially for 1,000+ weekend contests.

I then looked at the last 10 entries from the log in the QSO window. 
The info was all there including State and County etc.

I then selected the last contact in the log.
W3IH. The QSO window shows:
State NM
County Sierra

I did this check for about the last 20 contacts in the log worked on 30M.

When I look in 
Reports>WAS>Summary. Band, Mode, Mixed, All modes, All Bands selected
The Summary STILL shows 1 Worked and 3 Confirmed on 30M.
Reports>WAS>Listing shows STILL the same as the Summary.

I looked at the .ADI file that was imported and all the info was there.
That’s why the QSO window has all the info in it for State, County etc.

BUT

Why is
Reports>WAS>Summary. Band, Mode, Mixed, All modes, All Bands selected
and
Reports>WAS>Listing 
NOT being updated?

73,

Bud W3LL