[Dx4win] Expert mode and DX Doubler

[N4QS, Dave Perry]

Alan, I did have to install the lptdriver as you suggested, but I also had
to reset the LPT port address in N1MM+ to match the address for the new PCIe
card.   The DXD works fine now in N1MM, but I can't see a way to change the
address in DX4WIN.  I have emailed Paul.  Thanks for the assist.  73, Dave -
N4QS


-----Original Message-----
From: Alan Walters <abwltrs at aol.com> 
Sent: Sunday, December 16, 2018 3:18 PM
To: n4qs at vci.net; dx4win at mailman.qth.net
Subject: RE: [Dx4win] Expert mode and DX Doubler

Dave, I too am using my DX Doubler with 9.0.4 with Win7.  I wonder if you
have installed the lptdriver?  Assuming you installed DX4W directly in C:
drive, you will find this at C:/dx4w/drivers/lptdriver.

Al, K5NOF

-----Original Message-----
From: dx4win-bounces at mailman.qth.net [mailto:dx4win-bounces at mailman.qth.net]
On Behalf Of n4qs at vci.net
Sent: Sunday, December 16, 2018 12:51 PM
To: dx4win at mailman.qth.net
Subject: [Dx4win] Expert mode and DX Doubler

I am trying to reinstall my legacy DX Doubler SO2R box with DX4WIN ver
9.0.4.  It used to work great under version 8.5.  When I go to Preferences,
Control tab, I cannot change the Type or LPT1 port under Band Decoder.  With
version 9.04, the type is grayed out as None under Band decoder.  As I
recall, you used to have to go into the Personal tab to turn on expert mode
to change this, but that is no longer available.  Is Top Ten Devices using a
LPT port still supported in Version 9?  And can anyone tell me what happened
to Expert Mode?  Thanks,  Dave, N4QS

______________________________________________________________
DX4WIN mailing list
Home: http://mailman.qth.net/mailman/listinfo/dx4win
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:DX4WIN at mailman.qth.net
Message delivered to abwltrs at aol.com

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html