[Dx4win] ? abt IC 7300 interfaceing

[Jim Reisert AD1C]

On Wed, May 10, 2017 at 9:13 AM, Dean Norris K7NO wrote:

> I  am awaiting a new 7300 and wonder if there are any issues regarding interfacing it.  I am using dx4win as a log pgm.  Any suggestions?  Thx.

You could try using the IC-7600 radio driver (selection), but change
the hex address code from 7A to 94.  Let us know if that works.

Otherwise, you might want to take a look at the N4PY Radio Interface software:

    http://www.n4py.com/

It does support the IC-7300 (look for "New features now available").
It acts as kind of a software "shim" between the radio and DX4WIN.  If
I recall, it interfaces to DX4WIN using one of the Ten-Tec radio
selections.  I have tried it in the past, but did not have a permanent
need for it.  It's actually a solution for any radio for which DX4WIN
does not provide a built-in rig driver.

73 - Jim AD1C

-- 
Jim Reisert AD1C, <jjreisert at alum.mit.edu>, http://www.ad1c.us