[Dx4win] FT-991 RIG FILE

[Joe Subich, W4TV]

> 4. When selecting a DX SPOT that has a split it SETS the SPLIT A B
> not freq changes.
 > 4. THE FREQ DOES NOTHING no changes.
 >
 > So MODE is set, SPLIT mode is set, BUT no freq changes.

Sorry, I don't understand this and since I do not have an FT-991 I'm
blind as to the behavior.

73,

    ... Joe, W4TV


On 2015-03-30 8:49 AM, bob wrote:
> Hi Joe,
>
> Well progress.
> 1. I changed the radio and dx4win options as advised.
> 2. I turned off the radio and started DX4win and then started the radio.
> 3. I can click on DX SPOTS and the MODE is set.
> 4. When selecting a DX SPOT that has a split it SETS the SPLIT A B not
> freq changes.
> 4. THE FREQ DOES NOTHING no changes.
>
> So MODE is set, SPLIT mode is set, BUT no freq changes.
>
> Cool.....were getting somewhere.
>
> I patiently wait your next instructions.
>
> Bob
>
>
> On 3/29/2015 9:43 AM, Joe Subich, W4TV wrote:
>>
>> If you man no data at all from the rig, make sure that you
>> have checked RTS High in the Radio Setup (DX4Win Preferences)
>> and selected (RTS High) and set CAT TOT (menu 032) and 232C
>> TOT (menu 30) to 1000 depending on whether you are using USB
>> or RS-232 for control.  The default data rate for the FTdx3000
>> rig file is 38,400 bps - the rig default rate is 4800.  You will
>> need to reset menu 029 (232C Rate) or menu 031 (CAT rate) to
>> 38,400 depending on whether you are using USB or RS-232.
>>
>> If you are using USB, you will need to install the Yaesu USB
>> driver and the rig will need to be turned of *before* starting
>> DX4Win.
>>
>> 73,
>>
>>    ... Joe, W4TV
>>
>>
>
>
> ---
> This email has been checked for viruses by Avast antivirus software.
> http://www.avast.com
>
>