[Dx4win] IC-7600 Problems Clicking on Spots

[Dick Maylott via DX4WIN]

I recently upgraded my Icom 756 Pro III for a new Icom 7600.  I use a  
Rigblaster Advantage for interface and nearly everything works fine.   However, 
when I double click on a spot on either the packet window or the band  map, 
the mode changes as needed on the radio, but the frequency usually  does 
not. Repeated double clicking sometimes works after a  while.  Generally, It 
will briefly show the spotted band  in the  band window, but then defaults in 
a few seconds to whatever frequency is on the  VFO at the time.   However, 
if a QSX frequency is shown in the packet  window, it readily puts that 
frequency in the main VFO.  I have tried both  the 250HZ and 500HZ versions of 
the radio control (ON4AOI - 01/02/2011) with no  difference (why do they even 
exist).  When in logging mode, the radio  frequency is shown OK in the 
logging screen, although it changes rather  slowly.  I'm using version 8.05.  The 
spotting interface works fine in  band maps for N1MM and Writelog.  
 
73, Dick, W2YE