[Dx4win] mmtty

[Joe Subich, W4TV]

 > something in DX4WIN is not working with the router... ideas?

No ideas.  When I prepared the example documents everything was
working exactly as documented with DX4Win 8.05 which was the then
current working demo.  I did not install the demo on my newer
systems and could not test with any newer software in any case.

The typical cause of a "can not open port" message is an improper
configuration - more than one program accessing the same port - or
a port conflict - attempt to define a hardware port and virtual
port to the same number.

73,

    ... Joe, W4TV


On 2015-02-03 11:49 AM, Courtney Judd wrote:
>
> found another isue very similiar. I tried to get DX4WIN to use WINKEY
> which works great in Writelog using the key or F messages. In DX4WIN the
> key will work but when you open the keyboard window a message pops up
> saying that it could not open the winkey port... something in DX4WIN is
> not working with the router... ideas? Cort
>> Joe Subich, W4TV <mailto:lists at subich.com>
>> Tuesday, February 03, 2015 9:00 AM
>>
>> Cort,
>>
>> As always, start with the example configuration for DX4Win and MK II
>> from microHAM.  In Router (Help | Download Documents) or on-line in
>> the MK II area at www.microham-USA.com/support.html.
>>
>> DX4Win's support for MMTTY is a bit strange in FSK in that you must
>> run MMTTY stand alone from the same path as used in DX4Win to configure
>> the FSK port and set Configure MMTTY | MISC | TX Port to "COM-TxD(FSK)"
>> because there is no way to pass the port/FSK setting from the DX4Win
>> MMTTY window.
>>
>> 73,
>>
>>    ... Joe, W4TV
>>
>>
>>
>> ______________________________________________________________
>> DX4WIN mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/dx4win
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:DX4WIN at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>>
>