[Dx4win] IC7410 agn

[Bob at n2scj.net]

I have my IC-7410 working with a USB cable only between radio and PC.  No 
CI-V cable.  I click on a spot and rig changes to that freq.  If I tune 
around and stop on a freq, eventually DX4Win displays the frequency.   My 
setup parameters are:

Type - ICOM 756
Address - 80
Baud Rate - 1200
Com Port - 5    (I assume yours may be different)
Poll rate (ms) - 5000
Max tries 6
DTR high is checked
RTS high is not checked

Transverter offset 0 - I do not use a transverter
Band - None

I also have it working with N1MM logger.  I have not tried rx or tx audio to 
the radio, though I believe the rig supports audio over USB cable.

Bob
-----Original Message----- 
From: Rick Murphy
Sent: Tuesday, November 26, 2013 1:55 PM
To: DX4WIN
Subject: Re: [Dx4win] IC7410 agn

On Tue, Nov 26, 2013 at 12:23 PM, Hans Thorgren <hans at thorgren.se> wrote:

> Hello,
> I haven´t solved how to connect my IC7410 to DX4WIN. The suggestions I
> have got dosen´t work. The address must be two letters or numbers not 
> three
> so 80H doesn´t work
>

"80H" means 80 Hexadecimal.   (as does 0x80). So have you tried just 80?

The rig is not on the inbuilt list so far as I know. Do I have to buy a
> CI-V unit? Have anyone succeded?
>

Well, you'll need a CI-V cable, but that should be it.
73,
    -Rick
______________________________________________________________
DX4WIN mailing list
Home: http://mailman.qth.net/mailman/listinfo/dx4win
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:DX4WIN at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html