[Dx4win] CQ ZONES

[ALAN ZACK]

I have looked at my D4W log to see if mine acts the same but does not.

For an example I have only worked RN0SA in Zone 18 on 15M CW. That shows as
a W in the small WINDOW: ZONE window. I worked and confirmed several
stations in Zone 18 on 15M SSB which show C in the small WINDOW: ZONE
window. When I open the large REPORTS: WAZ window Zone 18 for 15M shows a S.
So the large REPORTS WAZ window doesn't care if I confirmed Z18 on 15M CW or
SSB, just that I have it on one or the other. I have my settings to ALL
BANDS and ALL MODES so that may let me see if it was confirmed on either CW
or SSB so it is ignoring that I do not have the CW contact confirmed. I know
this doesn't answer your question but just wondering if your BANDS and MODES
settings in the REPORT GENERATOR window for WAZ are causing you to see what
you are seeing. If it is not now set to ALL BANDS and ALL MODES and see if
that makes a difference.

73, GL, and HNY
Alan K7ACZ

  
-----Original Message-----
From: dx4win-bounces at mailman.qth.net [mailto:dx4win-bounces at mailman.qth.net]
On Behalf Of Ed Hughes
Sent: Friday, December 28, 2012 10:26 AM
To: DX4WIN at mailman.qth.net
Subject: [Dx4win] CQ ZONES

I have worked station UA0KZ on both 17 & 30 meters. DX4Win sez CQZone 19.
When I look at the DX4Win Window called "zone", it shows a "W" for both 17 &
30 meters.
When I go to "reports waz" and ask for a listing, the report has a "W" for
30 meters for
zone 19 (as it should), but zone 19 for 12 meters is blank.

I have a simular situation with station RW9HZZ zone 18. Worked on 12 meters.
When I look at the DX4Win Window called "zone", it shows a "W" for 12
meters.
When I go to "reports waz" and ask for a listing, zone 18 for 12 meters is
blank.

Ed
KG4W