[Dx4win] DX4WIN version 8.05

[Jim Reisert AD1C]

On Sun, Jan 30, 2011 at 6:36 PM, Dick Flanagan <dick at k7vc.com> wrote:

> Anyone know if this version will also support the ICOM IC-7700 (Firmware 1.20)?

My guess is NO.  However, try setting the hex address in your -7700 to
match that for the -7800, then tell DX4WIN you're using an IC-7800.
It might just work.  Same goes for the -7600.  I imagine the new ICOM
(read split) commands in all three radios are the same, but I don't
think Paul had access to either the -7600 or -7700 for testing.  If
you can help him, it would help everyone.

73 - Jim AD1C

-- 
Jim Reisert AD1C, <jjreisert at alum.mit.edu>, http://www.ad1c.us