[Dx4win] Ver 8.05 CW?

[Mel]

You have to install the LPT driver. It's a separate step in the 
installation process.

On 2011-02-16 20:26, Mike Bragassa wrote:
> I cannot seem to get CW to key after the upgrade from ver.7.02 (and previous) which have always upgraded w/ no problems.
> Within Setup Parameters|CW I choose DX4win and LPT1 as I have always done.
> I noticed that once I:
> 1. Move up or down in the selections of Setup Parameters|CW and return to the CW tab, the LPT1 selection is...gone.
> 2. When I exit Setup Parameters, of course saving the changes and go to test CW: No CW..
>
> For some reason the LPT1 setting is not being saved.
>
> What is "1/2 Signal | None or Reverse" ?  I had "1/2 signal" selected in my previous version. Why? I don't recall. None of these seem to affect my problem above.
>
> The upgrade has been registered.
>
> Any ideas before I go back to my previous version?
>
> 73  de Mike, K5UO
> bragassa at consolidated.net
> ______________________________________________________________
> Dx4win mailing list
> Home: http://mailman.qth.net/mailman/listinfo/dx4win
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Dx4win at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>