[Dx4win] ADIF V2.19

[Jim Reisert AD1C]

I would need to see the EXACT message.  I've never seen such a message
when I uploaded logs to eQSL.  I would hope that the error message had
more detail about what modes it thought were illegal.

73 - Jim AD1C

On Mon, Aug 23, 2010 at 6:54 AM, Bud Governale, W3LL <w3ll at arrl.net> wrote:
> The upload modes were a combination of RTTY and SSB. The version of DX4WIN was 8.04.
>
> I had no trouble with the upload. It appeared to go well.
>
> I was just curious about the eQSL upload statement at the bottom of the  results page about the ADIF version spec non
> compliance.
>
> 73,
>
> Bud W3LL
>
> ----- Original Message -----
> From: "Jim Reisert AD1C" <jjreisert at alum.mit.edu>
> To: "Bud Governale, W3LL" <w3ll at arrl.net>
> Cc: <dx4win at mailman.qth.net>
> Sent: Sunday, August 22, 2010 9:49 PM
> Subject: Re: [Dx4win] ADIF V2.19
>
>
> On 8/22/2010 4:40 PM, Bud Governale, W3LL wrote:
>
>> I saw the following statement when I uploaded QSO's to eQSL.
>> Is DX4WIN in compliance with the spec?
>>
>> "Logger not compliant with ADIF V2.1.9 specs due to invalid mode(s)
>> Logger identified as: DX4WIN"
>
> What was the mode that it complained about, and what version of DX4WIN
> were you using?  I have had NO trouble uploading to LoTW and eQSL using
> 7.07 and 8.0x.  Note that "PSK" is *not* an ADIF mode, you must choose
> PSK31 (or PSK63 if it's available).  This is a common mistake.



-- 
Jim Reisert AD1C, <jjreisert at alum.mit.edu>, http://www.ad1c.us