[Dx4win] COM Ports (again)

[Kostas Stamatis]

I syggest to run mmtty first.
Pse check if any port is checked there (in mmtty)
If yes uncheck them (if you run afsk)
if you run fsk uncheck only the radio port and check the ptt/fsk port
run dx4win now
under file>preferences>radio you must have the radio port, that is com3
and under file>preferences>cw check com2 and ptt control under rts line

Run mmtty inside dx4win
right click in bottom of mmtty window and choose keying setup. Here  check 
ptt control and rts agn.
one disavantage of dx4win-mmtty combination, is that you can not use the 
same com port for ptt and fsk.

73 Kostas sv1dpi

----- Original Message ----- 
From: "John Holmes" <w9ily at arrl.net>
To: <dx4win at mailman.qth.net>
Sent: Wednesday, May 27, 2009 12:48 AM
Subject: [Dx4win] COM Ports (again)


>I just encountered a problem that had not previously appeared. I'm running
> version 7.07.02 and can no longer have both radio control and MMTTY 
> running
> at the same time. MMTTY is assigned to COM2 and radio control to COM3. I 
> can
> either run MMTTY or have radio control, not both. They are connected to a
> two port serial card with one port assigned COM2 with an I/O range of
> AC00-AC07 IRQ22 and the other port is assigned COM3 with an I/O range of
> A800-A807 and IRQ22. Yes, the IRQ numbers are the same, but it's virtually
> impossible to manually change them in XP Home. When using N1MMLogger, I 
> have
> no problems, but do with DX4Win. I even tried loading two of the previous
> versions of DX4Win but there is no difference. I am certain that this 
> worked
> OK in the past. Any ideas, guys? Thanks.
>
> John W9ILY
>
> ______________________________________________________________
> Dx4win mailing list
> Home: http://mailman.qth.net/mailman/listinfo/dx4win
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Dx4win at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>