[Dx4win] omnirig

[Kostas SV1DPI]

i have seen that many have problems one or other way with rig control. 
Dx4win is not the problem the most of the time. But maybe it's time Paul and 
dx4win supports omnirig, a free cat control program. It would be an 
alternative in every case... Either for a new rig or even to check if there 
is a problem in dx4win or in your radio (this can be done and today). 
Besides this someone will have the ability to run 2 programs which both 
support omnirig the same time... Just a wish.... see omnirig here 
http://www.dxatlas.com/omnirig/

Kostas sv1dpi

----- Original Message ----- 
From: "Joe Stepansky" <kq3f at comcast.net>
To: <dx4win at mailman.qth.net>
Sent: Saturday, November 15, 2008 10:51 PM
Subject: [Dx4win] DX4Win doesn't recognize the rig


> For whatever reason, my newly installed DX4Win 7 won't see my rig.  I had 
> no
> problem with version 6, but I've seemingly tried everything and it won't 
> go.
> I'm running this through RigBlaster PRO.  All the connections appear to be
> fine (nothing changed between the time my old computer went bye-bye and 
> this
> one).  I'm connected from Serial In/Out A to COM1.  Rig control on the
> Rigblaster is connected to CI-V remote jack on the 756 PRO II.  Here's the
> set up under the Preferences/Radio tab:
>
>
>
> Type - Icom 756 PRO II
>
> Address - 64 (I've verified the address on the rig screen)
>
> Baud - 9600
>
> Com Port - COM1
>
> Poll Rate - 5000
>
> Max Tries - 6
>
> DTR High - Off (When I leave this on the rig keys continuously)
>
> RTS High - Off (When I leave this on the PTT is on continuously)
>
>
>
> Any ideas?
>
>
>
> 73, Joe KQ3F
>
>


--------------------------------------------------------------------------------


> _______________________________________________
> Dx4win mailing list
> Dx4win at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/dx4win
>