[Dx4win] K3 and Split Operation

[Bruce Meier]

Tonight I was testing DX4Win version 7.04.04 to see how it worked with the
K3.  Everything I tested seemed to be fine except for how it managed the DX
Cluster with split frequency spots.   I sent a test spot for two freqs on 80
with the K3 set to split op.  The spot appeared to be correct in the cluster
display.   I then cleared the log window and changed the band of the K3 to
40.  After clicking on the spot the frequencies were correct but the K3 did
not go into split mode.  The TX focus stayed on VFO A.    I then closed
DX4win and opened Write-Log and tried the same test using the spot sent from
DX4Win.   Write-Log worked fine, going to the correct frequencies and TX
focus was on VFO B as it should be.

Any suggestions?

73,
Bruce - N1LN
(aka: NC4KW)