[Dx4win] Freq doesn't change properly when clicking a spot.

[Kjell W. Strom]

Guy,
 
As far as I can see, the rig files are identical to previous
versions. In FT-1000 the offset is added internally direct to
the display.  It looks like v.7.06 now is adding an offset to
the actual frequency before it is sent to the radio every time
when a change of mode command is sent. This may be right for the
two rigs you had problems with, but not for the 98 percent which
worked OK before. 
 
You must step backwards to the point where the "fix" was applied
and make sure that it is limited to the few problem radios.
Maybe Paul can get away by adding an IF...ELSE statement...
 
73,
Kjell, PB3SM - SM6CPI
 
 


  _____  

From: dx4win-bounces at mailman.qth.net
[mailto:dx4win-bounces at mailman.qth.net] On Behalf Of ON4AOI
Sent: 11 December 2008 20:33
To: k2waltk at gmail.com
Cc: dx4win at mailman.qth.net
Subject: RE: [Dx4win] Freq doesn't change properly when clicking
a spot.



Hi all,

 

Yes the CAT part of the program is changed , Paul and I spend
much time in solving the problem 

For the OMNIVII rig and the K3 rig, but didn´t found or have any
problems with my IC7800.

 

 

If you are aware how to change a rigfile via the radio database
(closed log )

 you can try to give a little delay (100ms) next to the command
line for  

 

set vfo A or 

set vfo B or 

set mode or

set mode B  

 

make sure you make a backup of the rigfile first
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

 

In the omniVII file we had to put a 100ms delay in one cmdline
because the radio 

couldn´t process the correct sended commands.

 

Guy ON4AOI   

 

Van: dx4win-bounces at mailman.qth.net
[mailto:dx4win-bounces at mailman.qth.net] Namens k2waltk at gmail.com
Verzonden: donderdag 11 december 2008 18:21
Aan: dx4win at mailman.qth.net
Onderwerp: [Dx4win] Freq doesn't change properly when clicking a
spot.

 

Hey all,

 

Version:   DX4Win 7.06.02

Rig:           IC756 Pro III

 

If I am on CW and I grab an SSB spot, the frequency I’m taken
too is

offset (low) from the actual frequency by the amount of the
offset

I use on CW. A second double click on the spot corrects this
anomaly.

 

Any ideas as to what is causing this problem?  Previous
versions, 

i.e. dx4win7.05 didn’t exhibit this behavior.

 

 

                 Regards,



 

                            Walt Kornienko - K2WK

                            Gordonsville, VA 22942-6110
                            k2waltk at gmail.com

                            k2wk at arrl.net



 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mailman.qth.net/pipermail/dx4win/attachments/20081211/2939b54f/attachment-0001.htm