[Dx4win] K3 / Split / DX cluster

[Bruce Meier]

I will ask again..

The first time I asked I did get a couple off reflector replys that I was
not alone seeing this bug in DX4Win and . one responder also pointed out
that not only did DX4win not put the K3 into SPLIT mode, but it also did not
change the mode of VFO B.

As asked before - 

Tonight I was testing DX4Win version 7.04.04 to see how it worked with the
K3.  Everything I tested seemed to be fine except for how it managed the DX
Cluster with split frequency spots.   I sent a test spot for two freqs on 80
with the K3 set to split op.  The spot appeared to be correct in the cluster
display.   I then cleared the log window and changed the band of the K3 to
40.  After clicking on the spot the frequencies were correct but the K3 did
not go into split mode.  The TX focus stayed on VFO A.    I then closed
DX4win and opened Write-Log and tried the same test using the spot sent from
DX4Win.   Write-Log worked fine, going to the correct frequencies and TX
focus was on VFO B as it should be.

Is this BUG on the list to be addressed?

73,
Bruce - N1LN
(aka: NC4KW)

K3 #1062
K3 #1193