[Dx4win] Announce DX Question

[Ed Roberts]

Jim & Larry--thanks for the responses!
I am connected to K2UT---FRC node in Medford NJ usually---It is near to my 
QTH.
I  connect using TCP/IP protocol (com port), i.e. the internet.
Receiving the spots in Dx4win works just fine. When I see the spot I have 
just announced, using 'Announce Dx' from Dx4win it always shows up in the 
remark column appended/following the remark without a space----with the 
spotter column left blank. I have tried other packet nodes in the past, with 
the same result!
funny business---huh?
Thanks again---Ed  W3EWR

----- Original Message ----- 
From: "Jim Reisert AD1C" <jjreisert at alum.mit.edu>
To: "Ed Roberts" <roadk1ng at hotmail.com>; <dx4win at mailman.qth.net>
Sent: Saturday, February 25, 2006 9:58 AM
Subject: Re: [Dx4win] Announce DX Question


> At 05:28 PM 2/24/2006, Ed Roberts wrote:
>
>>I am using Ver 7.01..  When I try to Announce DX my callsign always 
>>appears appended in the Remarks Column of the DX spots window & never in 
>>the Spotter column, which always is left blank. Any body know what I am 
>>doing wrong?
>
> Ed, what packet node are you connected to?  Is it RF or Internet (telnet)?
>
> This sounds like a problem with your cluster node, not the program.
>
> 73 - Jim AD1C
>
>
> -- 
> Jim Reisert AD1C, 7 Charlemont Court, North Chelmsford, MA 01863
> USA +978-251-9933, <jjreisert at alum.mit.edu>, http://www.ad1c.us
>
>