[Dx4win] Problem with Maximum QSOs Limited to 3 on a Custom Label

[Cliff Ahrens]

Is anyone able to print more than 3 QSO's on a custom label in DX4WIN 7.01?
I'm printing a custom label which is designed with a label height with room
for 5 QSO's on a Dymo 400 Turbo Labelwriter.  With the font, and font size
selected, the label has room for 5 QSOs plus the greeting line at the
bottom.  With max QSOs set to "0" as instructed, the greeting line prints OK
on the bottom of the label, and there is plenty of blank space for 5 QSO
lines, but only 3 print per label.  The preview of the label in edit mode
with "sample" QSO information ("Callsign 1" etc) shows 5 QSOs fitting on the
label.  But the preview of the actual QSO infomation as well as the printout
is limited to 3 Q's, with blank space for more.  
 
I've tried changing the "Max QSOs" from 0 to 5 and even greater, and still
only 3 print per label.  I've also tried changing the fonts and font sizes,
with no luck.  I also tried a different custom label with even greater label
height which would allow more than 12 QSOs per label.  On the preview, it
showed more than 12 QSOs per label, but again, the actual printout was
limited to 3 per label.
 
Anyone run into this issue?  Paul, Steve, or anyone on the reflector, any
suggestions?  Thanks!
 
Cliff  K0CA