[Dx4win] Cable interface

[Isidro Acosta Hernández]

Hi Jo, and the fellows in the reflector...

>I also need the answer. Could someone be kind enough to translate this
> into English, please? Tnx es 73 de Jo, YC0LOW

Sorry, I didn't think my message could be of general interest :) ...  Here
is:

The cables you need depend on what do you want to do.  To control the radio
with DX4Win, you need the proper CAT cable for your radio.  To operate on
digital modes only, you need a shielded cable from the LINE OUT connector
on your PC to the TX audio input on the radio (preferably not the MIC
input, but some other for higher signal level), and another similar cable
from the RX audio output on the radio to the LINE IN connector on the PC.
You might need some adapting circuit between both equipments, but I use
only the cables with good results.

Best season greetings!

73 de Isidro, EA8NQ
E-mail:  ea8nq at hotmail.com

---------------------------------------
Visit the EA8NQ's DX Page (in Spanish):
http://www.ure.es/ea8nq/
---------------------------------------