[Dx4win] dx4win and ft1000mpmv and ft1000mp

[Pete Smith]

I am running 6.03 with a Mark 5 as radio 1 and a Kenwood as radio 2.  For 
the Mark 5, the polling rate (as reflected by the CAT light on the front 
panel) is regular but very slow (about once a second).  Checking my 
settings, I found that the polling rate is set at 500 ms.  I changed it to 
100 ms and, to my surprise, there was no change in the frequency at which 
the CAT light flashes.  I don't know if this is related to Timon's problem 
or not.

73, Pete N4ZR

At 08:26 AM 6/22/2005, Timon PA1T wrote:
>Gentelmen,
>
>I am running a ft1000mp m5 as radio 1 and a ft1000mp as radio 2.
>Using micraham bandecoders and doubel ten switch box.
>
>When I run n1mm contest software at both radio's the cat led is blinking all
>the time in a normal rithem.
>
>When I run dx4win and run the mark 5 as radio 1 the cat is blinking 6 times
>ans the it stops for about 6 seconds. The second radios cat is blinking ok.
>When I make radio 2 the 1000 mp radio 1 the cath is blinking one time waits
>four seconds an blinks again.
>
>I think that if a radio is selected that cat has to blink in a normal rithem
>as it does at the n1mm software.
>Maybe something for a next update.
>I am runnig 6.04
>
>73 Timon pa1t
>
>Email Pa1t at amsat.org
>Home page www.pa1t.com
>
>
>_______________________________________________
>Dx4win mailing list
>Dx4win at mailman.qth.net
>http://mailman.qth.net/mailman/listinfo/dx4win