[Dx4win] GRABING SPLIT SPOTS

[T.M. Rose]

Have upgraded from DX4Win v.5 to v.6 and resetting everything. Down to the last challenge...I hope. When I grab a spot and there is a single (duplex) freq shown the radio responds, a little slow but it grabs the freq fine. 

The problem is that when there is a split freq shown, QSX, the radio wants to go to the QSX freq not the spotted freq. The radio will show "split" but the radios freq is on the QSX freq. This never happened with v.5.

I am using a Ten-Tec Omni VI that was upgraded to + years ago. Using the Icom 735 setting @ 04 and 9600 baud. The poll rate is set at 20ms and the RTS high is checked. It seems that the program is having a little problem communicating with the radio.

Any thoughts?

Tom  k0zm