[Dx4win] DX4WIN_PACKET_KAM_COMMUNICATIONS?

[A. Sewell]

George,

It's been a while since I used my KAM with DX4WIN but as I recall you 
want to be in "converse" mode when sending commands to the dxcluster.  
When you have a command prompt just type k<CR> and that will put you in 
converse mode.  When in converse mode enter "control-C' to return to 
command mode.

When you first connect to the cluster it should go to converse mode 
automatically.  If not, you can use the CONMode command to set what mode 
it is in after a connect..

73,

Alan  N5NA

George K wrote:
> I think I figured out how to toggle between the transparent (send messages to the packet), and command, (send messages to the KAM), modes. 
> By reading the KAM manual I was able to figure out how to do this.
> Three "control-C" enters the command mode, conversely sending a "t" exits the command mode and enters the transparent mode.
> Does this sound like what others are doing when using the KAM with DX4WIN???
> Thanks.
> George
> _______________________________________________
> Dx4win mailing list
> Dx4win at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/dx4win
>
>