[Dx4win] MMTTY IN DX4WIN

[Jay Sewell]

Credit goes to Bob, W5OV for the following.

Assuming you have MMTTY running stand-alone and correctly PTT keying the
transmitter and sending FSK when your rig is in rtty mode running through
the MicroKEYER.    Get that set up first and running properly and then
don’t change anything in MMTTY.  Then close MMTTY

Then the following Settings:

MicroKEYER
     Virtual Port menu, create COM3 COM4 AND COM5
     Device menu:  load template for DX4WIN
   Then set
       Control  COM3
        FSK   COM5   
        CW       COM4    DTR
        PTT   COM5     RTS
then Preset menu
        Save as, and name it DX4WIN

A button will appear at the bottom that will allow you to recall the above
settings.  You can do the same for MMTTY stand-alone or other programs you
use.  If you make any further changes remember to save it again.

Differently numbered COM ports may be used but the numbers used above must
match those below.

 In DX4WIN
  File,  Preferences,  
    Radio:   Set radio type to your radio, 
         COM port to COM3
    Control,  CW keying/PTT control
         Interface COM4   
         DTR line CW keying    
         RTS line PTT control                           
    RTTY tab, RTTY Interface  TYPE  None
          MMTTY at bottom set path to mmtty.exe
   Save settings

Open the MMTTY window within DX4WIN then from within MMTTY window hit Alt-S
which will call up a small window named MMTTY keying setup
     Set PTT CONTROL and in key line click RTS
     (Don’t set a COM port in this window)

It should run now..

73,  Jay  W5SL

----- Original Message ----- 
From: George Frost 
To: w5sl at earthlink.net
Sent: 8/25/2005 8:34:09 PM 
Subject: RE: [Dx4win] MMTTY IN DX4WIN


Jay  what was the solution? KF9WV ....GEORGE

Jay Sewell <w5sl at earthlink.net> wrote: 
Thanks to all who replied. With the kind help of Bob, W5OV, the problem
was solved. MMTTY works very well FSK with DX4WIN now.

73 Jay W5SL


> [Original Message]
> From: Jay Sewell 
> To: 
> Date: 8/24/2005 9:47:53 PM
> Subject: [Dx4win] MMTTY IN DX4WIN
>
> I cannot transmit FSK with MMTTY inside DX4WIN. Receives fine. I am
trying to set up FSK through MicroKeyer. All I am able to get is keying of
the rig with a solid tone, no diddle, no transmission of data.
> 
> MMTTY works fine stand-alone and works fine with N1MMLogger through the
MicroKeyer, but MicroKeyer refuses to recognize MMTTY for transmission of
data from inside DX4WIN.
> 
> Any suggestions?
>
> Thanks and 73,
> Jay W5SL
> _______________________________________________
> Dx4win mailing list
> Dx4win at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/dx4win


_______________________________________________
Dx4win mailing list
Dx4win at mailman.qth.net
http://mailman.qth.net/mailman/listinfo/dx4win

Jay Sewell
w5sl at earthlink.net