[Dx4win] Internet DX Spot Configuration

Wed, 26 Nov 2003 15:46:41 -0500

I just went through the same thing.  You need to then right click
on the spot window and select internet connection.  The file
dx4win.tcp will pop up a selection to choose from.  In my case I
wanted to use one that is new, W3LPL, so I added it.  This is not
a convenient as a TNC though as you need to go through these
steps each time you start DX4WIN whereas a TNC will just listed
with out any prompting when DX4WIN starts.

73 Stan, N3HS

-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Dick Wilson
Sent: Wednesday, November 26, 2003 3:30 PM
To: [email protected]
Subject: [Dx4win] Internet DX Spot Configuration

I just got a high-speed Internet connection and coincidentally my
packet TNC
developed an intermittent and very annoying problem.  I was
hoping that
changing my configuration to get DX spots from the Internet would
be simple
but I don't find much about it in the manual other than to select
TCP/IP in
the com port selection.

I am running version 5.02.  Can someone supply the correct
configuration for
using the Internet and perhaps a couple of web site names I might
try?

Thanks,

Dick Wilson
WD8DW

_______________________________________________
Dx4win mailing list
[email protected]
http://mailman.qth.net/mailman/listinfo/dx4win