[Dx4win] IC-718

Sun, 9 Nov 2003 08:20:09 -0500

It should work with any Icom driver... You will just have to plug in the
necessary hex address for the interface "5E" and set the baud rate...
And it should work fine.

Some of the later drivers might support some additional functionality...
(S-meter for scanning ?)

I'd try the 756 then 775 then generic drivers and take the first one
that works correctly...

> -----Original Message-----
> From: [email protected] 
> [mailto:[email protected]] On Behalf Of Terry Ashland
> Sent: November 7, 2003 13:42
> To: [email protected]
> Subject: [Dx4win] IC-718
> 
> 
> Please forgive me if this has been asked before, but what 
> is the setting for an IC-718?  I don't see it listed.  I 
> don't have it yet, but will have it soon.  I plan on using 
> K1NU interface cable (CT-IV) for it.  Does this combo 
> (radio and cable) work with DX4WIN (and Writelog)?
> TIA and 73,
> Terry, WK0F
> _______________________________________________
> Dx4win mailing list
> [email protected] http://mailman.qth.net/mailman/listinfo/dx4win
> 