[Dx4win] V6.01 SO2R

Thu, 30 Jan 2003 00:04:34 -0000

Hi Roger,
To me it looks like your DEVICE can't handle correctly the output from LPT
port
or doesn't switch like it is intended to work.

How it works,

WHEN RADIO1 is SELECTED and if 1/2 signal is selected, your LPT1 PIN 14 is
HIGH = + 5Volt
NOW SHIFT+CTRL+F12
AND RADIO2 is SELECTED also with 1/2 signal selected, your LPT1 PIN 14 is
LOW = 0 Volt

Go to my web and look @ the picture I putted on a few minutes ago

73 Guy ON4AOI

BAND DECODER and related stuff at
http://www.on4aoi.be/banddecoder.htm

DX4WIN soft and related stuff at
http://www.on4aoi.be/dx4win.htm

DX4WIN, WRITELOG, WF1B & RITTY CW & RTTY interfaces at
http://www.on4aoi.be/keyer.htm

ARSWIN link and related stuff at
http://www.on4aoi.be/web7.htm

DXTELNET soft and related stuff at
http://www.on4aoi.be/dxt.htm

MY SALESPAGE with radioamateur & computer parts
http://www.on4aoi.be/sale.htm

----- Original Message -----
From: "Roger Marrotte" <[email protected]>
To: <[email protected]>
Sent: Wednesday, January 29, 2003 10:55 PM
Subject: [Dx4win] V6.01 SO2R

> I was just fooling around with the new version of DX4WIN and trying to set
> it up for SO2R.  I have a Kenwood TS-2000 and an Elecraft K2.  My SO2R box
> is a Top Ten Devices DX Doubler.  Up until now while using DX4WIN I would
> just go to preferences and change the radio port and the radio type to the
> correct values for the radio I wanted to use.  This worked fine but was a
> little cumbersome.  After trying a few things I find that with V6.01 I can
> do the same thing (just set up one radio in preferences) and it seems to
> work the same way.  The freq and mode show up OK.  When I set up two
radios
> in preferences and if I leave the DX Doubler in manual mode the freq and
> mode are read correctly and change to the other radio's values when I hit
> SHIFT-CTRL-F12 (the new V6.01 command to switch to the other radio). I
must
> manually switch the DX Doubler to get to Mike , earphones, etc. to the
> correct radio (because it's in manual mode). All works well in this mode.
> When I put the DX Doubler into AUTO mode I have a problem.  The
> SHIFT-CTRL-F12 command switches the DX Doubler to the other radio and the
> mode/freq displayed follows the radio change correctly but both radios are
> put into transmit mode with a sidetone as if the CW line is set on for
both
> at the same time.  No matter what I do this does not change. The CW keyer
> interface in preferences is set to LPT1 and the radio 1/2 signal is set to
> LPT1.  I've shut each off one at a time with no luck.  I've tried
different
> setting for DTR and RTS in preferences with no luck. HELP
>
> Roger, W1EM
>
>
>
> _______________________________________________
> Dx4win mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/dx4win
>
>