[Dx4win] IC-765 control question

Tue, 30 Dec 2003 01:58:51 -0500

Not true Paul... The Mode command can simultaneously set width... but
I'm sure if one can get at the necessary bytes with DX4Win... I'll take
a look tomorrow.

> -----Original Message-----
> From: [email protected] 
> [mailto:[email protected]] On Behalf Of Paul Ferguson
> Sent: December 29, 2003 17:07
> To: [email protected]
> Subject: Re: [Dx4win] IC-765 control question
> 
> 
> > We noticed that clicking on a CW spot would properly send 
> the radio to 
> > the frequency, but would set the CW filter to Wide.  Is there a 
> > modification to the radio control file for the 765 which 
> will send the 
> > radio to the proper frequency but set the filter at Narrow?
> 
> ICOM did not provide, in the IC-765 CI-V interface, a command that 
> will set the Wide versus Narrow mode for the IC-765 IF passband. If a 
> program sends a command to the IC-765 to set the operating mode, the 
> 765 will set wide mode. 
> 
> If you can make the radio control fiileset just send the set 
> frequency command, the mode will be left where it was previously set 
> (such as CW-Narrow). 
> 
> 73,
> Paul
> K5ESW
> 
> _______________________________________________
> Dx4win mailing list
> [email protected] http://mailman.qth.net/mailman/listinfo/dx4win
> 