[Dx4win] Version 6.02 - Win XP Pro - program won't start

Sun, 10 Aug 2003 10:02:47 -0400

The short answer is you have to be administrator...

Under XP you can't even set the clock if you are not administrator (by
default)

I haven't tried to puzzle out the minimum set of "rights" needed to run
DX4Win in a secure environment... But sounds like an interesting project
for a rainy day... If someone hasn't done it already...

-----Original Message-----
From: [email protected] [mailto:[email protected]]
On Behalf Of John Bednar
Sent: August 10, 2003 8:32 AM
To: DX4WIN Reflector
Subject: [Dx4win] Version 6.02 - Win XP Pro - program won't start

I tried to run version 6.02 today and program would not
start. Instead, the following error was displayed:
"Port driver not found check appendix: Files for the
correct driver". I checked Appendix D and could not find 
the error or any solutions in this section. 

After some experimenting, I did learn much later 
that the program starts correctly if my user level is 
set to "administrator" instead of "limited" user. I did try changing my
user level, re-installed 6.02 using my account, but DX4Win still won't
start with a limited account setting.

I don't remember seeing this problem mentioned earlier
so I suspect that it might have something to do with my configuration.
DX4Win is installed in the default directory. Does anyone have
suggestions other than being an administrator to run the program?

John

_______________________________________________
Dx4win mailing list
[email protected] http://mailman.qth.net/mailman/listinfo/dx4win