[Dx4win] ICOM 765 interface issue

[Floyd Sense]

Check the section "Radio Port Lines" in your DX4WIN setup parameters.  Check
the box "RTS High".

I run my 765 at 9600 - no reason to run it any slower than that.

K8AC
Floyd Sense in Angier, NC
----- Original Message -----
From: "Lou & Em Malzone" <lmalzon1@maine.rr.com>
To: <dx4win@mailman.qth.net>
Sent: Thursday, November 21, 2002 11:09 PM
Subject: [Dx4win] ICOM 765 interface issue


> I have an ICOM 765 that used to work with DX4WIN 4.08 and my last computer
> running NT 4.0
>
> I still have the ICOM 765 but changed computers and upgraded to 5.03. I
> still run NT 4.0.
>
> My problem is that I can no longer get the computer to key the rig when
> clicking on a DX spot. If the radio is 'Stopped', the spot appears in the
> QSO window. If the radio is 'Started', and I click on a spot, the radio
> times out and the interface is disabled (DX4WIN error message). At that
> point if I 'Start' the radio, the timeout repeats.
>
> I have the 765 set to COM2, 1200 baud, address 2C.
> I have COM2 set to 1200, default address, and default IRQ
>
> I have tried several combinations of baud rates and switched to COM1, but
> to no avail. The radio times out.
>
> If someone can relate to me their settings or what they did to get their
> 765 running, I would appreciate it.
>
> Thank you.
>
> Lou AA1UB
>
> _______________________________________________
> Dx4win mailing list
> Dx4win@mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/dx4win
>