[Dx4win] QSX Function of TS-850S

[Mike Rhodes]

Tim,
  My 850 behaves the same but this is the only radio-enabled logging program
I have used since I bought the rig so I assumed it is the typical response.
The QSX frerquency is loaded but you have to hit the 'TX-B' button to get
into split mode.

Mike / W8DN
DX4Win Since Ver 0.97

----- Original Message -----
From: "Timothy Coker" <res0a4ux@verizon.net>
To: <dx4win@mailman.qth.net>
Sent: Sunday, March 24, 2002 11:11 PM
Subject: [Dx4win] QSX Function of TS-850S


Hi, I cannot seem to get my TS-850S to QSX properly with spots. My radio
would do it no problem using Log Windows when I used to use their software
so I know my cable's pins should be configured properly. I can QSY with
correct mode to a spot without problem, but no matter the method of listing
QSX/up or whatever on a spot it will not work. I am using the Kenwood
850-950 setting. Here is what happens... I double click with mouse on a spot
that has Up 'x' or QSX frequency listed, my radio QSY's there, the radio is
actually setup properly for QSX frequency (RX VFO A, TX VFO B) but then is
immediately switched back to RX/TX on VFO A. It will not stay on split VFO
operation. I've played with the different options in DX4WIN and have looked
through the user manual, any suggestions please?

Timothy Coker - N6WIN
Private Pilot - Instrument


_______________________________________________
Dx4win mailing list
Dx4win@mailman.qth.net
http://mailman.qth.net/mailman/listinfo/dx4win